Primary router is a DSL/WAP modem/router in one and I can’t control the DHCP range which is 192.168.1.65-254) Router IP – 192.168.1.1/255.255.255.0 (Same subnet as my primary router and not within the DHCP range. I also was wired into the router for the setup (don’t plug into the WAN port on the router for upstream connections, only use the PC/LAN ports for both upstream and then to the individual computers)įor reference: DD-WRT v24-sp2 (08/07/10) std (SVN revision 14896) You should be in the Web GUI of the router. This is for a wired connection to my primary router which handles DHCP. Method 1: Flashing with Web GUI First do a hard reset on the unit that DD-WRT is to be loaded onto.
Dd wrt v24 how to how to#
I googled and found plenty of handy advice on how to do that. Gidday I have flashed my DLINK DIR-300 with DD-WRT v24-sp2.
Dd wrt v24 how to software#
This software is usually not officially supported by the original manufacturer of the router. Posted: Sat 3:41 Post subject: How to configure DD-WRT v24-sp2 to operate as repeater. I suspect the settings in the GUI that are defaulted to off/disabled may have been an issue and I don’t remember if on the first time I had changed these.Įither way here is what I did in-case anyone else finds this post and is having the same problem. DD-WRT is an alternate firmware available for Wi-Fi routers. I left the dd-wrt secondary router at 192.168.1.1 (I had done this on the original attempt but it still wouldn’t find the router.) With this DD-WRT is now also supporting the. DD-WRT: A wireless networking program that is designed to work with the Windows 2000 operating system DD-WRT v24 SP1 Build 10020 free download. By supporting special features of the Atheros wireless designs like half- and quarter channels and extended channel support DD-WRT is now perfectly suited for long range wireless links. The primary DHCP router is located at 192.168.1.254. DD-WRT v24 offers many new features, on of the most important is support of Atheros wlan chipsets and SOC designs. This time rather than following the wiki, i went with the intuitive method and now have a working solution.
0 kommentar(er)
